How to use laser cutting machine to cut with good results?

1. The cooling system should be grounded, and the water tank and waterway should be cleaned frequently. The temperature control point of the refrigeration temperature control water tank should be reasonable. Otherwise, the laser tube will be easily damaged and the power will be reduced due to condensation. The cold water head of the tube will fall off, the life will be greatly shortened, and sometimes it will not work, resulting in Keep changing tubes.

2. The water protection should be checked and cleaned frequently. The cooling water often fails to flush the water protection float switch or the water protection float switch does not reset. The short circuit method cannot be used to solve the urgent problem.
3. The air suction device should be inspected and cleaned regularly, and the fan duct should be cleaned. Otherwise, a lot of smoke and dust will not be discharged, which will seriously and quickly contaminate the lens and laser tube, making various mechanical and electronic components easily oxidized and causing poor contact.

4.Inspect the focusing mirror and reflector. The frame will become hot after working for a while, and the surface of the lens will become discolored and rusty; peeling and cracking are all items that need to be replaced. Especially many customers use atmospheric pumps and air compressors, which will cause damage to the focusing lens. Water quickly accumulates on the lens, so it is necessary to regularly check the cleanliness and quality of the lens optical system.

5.The working environment of the laser cutting machine should not be too harsh. If the ambient temperature is higher than 30 degrees and lower than 18 degrees, there is too much dust, and the air pollution is serious, the machine will be seriously damaged and the failure rate will continue to rise; various electrical accessories are easy