How to maintain the laser cutting machine in high temperature in summer?

In summer, the temperature rises everywhere, and many laser equipment will generate heat during use, causing some faults. Therefore, in order to avoid laser cutting machine failures during use in summer, everyone must pay attention to the maintenance and repair of the laser cutting machine, which can extend the service life of the machine.

In the hot summer, Datu Laser reminds you that whether you are going out to play or working outdoors, you must take measures to prevent heatstroke. We must not only be prepared to prevent heatstroke and cool down, but also maintain the laser cutting machine to prevent the machine from "heatstroke"

Water cooling

In hot weather, the deterioration rate of cooling water will also accelerate. It is recommended that laser cutting machine users use regular distilled water or pure water, and clean the scale regularly to avoid the scale attached to the laser and pipes affecting the laser power; pay attention to the cooling water temperature should not be too different from the air temperature. As the temperature in summer gets higher and higher, the working pressure of the cooling system of the laser cutting machine increases sharply. It is recommended to check and maintain the internal pressure of the cooling machine before the high temperature comes, and adjust it in time to adapt to the high temperature weather.

Lubrication

The guide rails should be cleaned regularly to remove dust and other debris to ensure the normal operation of the laser equipment. The racks should be wiped regularly and lubricated. The time should be adjusted to shorten the time by 0.5-1 times compared with the spring and autumn seasons, and the oil quality should be observed. For machinery working in high-temperature areas, the viscosity grade of the engine oil should be appropriately increased. The temperature of lipid oil is easy to change, and appropriate oil should be added to ensure lubrication without debris. Carefully check the straightness of the cutting table and the track of the laser cutting machine and the verticality of the machine. If abnormal, timely maintenance and debugging should be performed. The guide rails should be cleaned and lubricated regularly, and the motors should also be cleaned and lubricated regularly to keep the machine in the best condition at all times. The machine can move better during operation, cut more accurately, and the quality of the cut products will be higher.

Line

Check and replace aging wires, plugs, hoses, and connectors; Check whether the pins of the connectors of each electrical component are loose, and tighten them in time to avoid poor contact causing electrical appliances to burn out and unstable signal transmission.

Warm Tips

Note: Be careful of frost on the laser machine. Since the temperature of the water chiller is quite different from the ambient temperature, the laser and cutting head will frost, which will cause damage to the equipment and lens. Please increase the temperature of the water chiller. If you don’t know how to adjust it, please contact after-sales service in time to ask how to adjust it.

Even the most powerful machines need maintenance, so when the hot summer comes, protect your machine and keep it in the best condition at all times to bring greater benefits to yourself.