Laser cutting machine manufacturers solve dust problems!

Laser cutting machine is one of the most common cutting methods. It has high work efficiency and is easy to use. It is widely used in processing plants. However, dust will definitely be produced when using a laser cutting machine to cut various materials. After such tiny dust particles are generated, they will float in the air in large quantities, seriously affecting the air index and damaging the working environment. High concentrations of dust can also cause harm to workers working there, often causing respiratory diseases and other serious illnesses. Let’s talk about how laser cutting machine manufacturers deal with dust problems.

At present, common laser cutting machine dust removal methods are divided into two types: dry type and wet type. The dry type is to add a set of dust collection and dust collector equipment for the laser cutting machine. The wet type is to place the cutting process on the water to form a waterbed cutting platform, which uses the power of the water flow to absorb dust and clean it. Through a comprehensive comparison of the two methods, the dry treatment method, especially the blowing and suction cutting fume purification system, is very popular among users in processing plants because it is easy to install and use. The smoke and dust generated by laser cutting are concentrated directly under the incision of the product workpiece. Therefore, this product has an air suction port directly under the operating table. The bottom of the operating table is divided into uniform small suction areas. The smoke and dust generated can be controlled according to the method of inhalation. Collect in small cutting area.

There is also a sliding suction hose on one side of the cutting fume purification system platform. When dust is generated, the wind speed of the air blowing port will blow the dust to the suction port, thereby achieving the collection effect of small exhaust volume and high dust collection rate.

The dust collected by the equipment will be sent to the dust removal host for filtering. The main machine structure is the same as that of the centralized dust removal equipment for electric welding dust. The installed filter cartridge will block dust exceeding 0.3μm, thereby completing the cleaning process of cutting dust. This type of blowing and suction dust collector equipment can treat laser cutting dust with an efficiency of more than 90%, and the actual effect is quite outstanding. Because of its simple installation and low cost, it has become a popular dust removal method for laser cutting machines