Use a piece of flat and smooth white cardboard, lay it flat on the workbench, set the laser cutting head above it, and the height of the focusing lens from the cardboard is 10mm smaller than the focal length of the focusing lens. For example, if the focal length of the focusing l...

The main components and functions of the CO2 laser cutting machine:1.CO2 laser tube: the main energy source, also called laser generator. It is distinguished by the size of the laser power. Generally, the power is 40W/60W/80W/100W/120W/150W/180W/200W, etc. The greater the power, ...

Laser cutting machines will face loss problems in long-term use. Machine wear will affect cutting speed, cutting accuracy and cutting effect. The following are the problems and countermeasures that may occur when using laser cutting machines:1. Long-term use will cause the laser ...

The working principle of the laser cutting machine is to release energy when the laser beam is irradiated onto the surface of the workpiece to melt and evaporate the workpiece to achieve the purpose of cutting and engraving. The laser cutting machine has the characteristics of sa...

Carbon steel is an iron-carbon alloy with a carbon content of 0.0218% to 2.11%. Theoretically, the higher the carbon content in carbon steel, the greater the hardness, the higher the strength, and the lower the plasticity. So what are the advantages of fiber laser cutting ma...

Handheld laser welding is a new welding technology that is rapidly gaining popularity. Its principle is to quickly melt materials with laser to form a weld, thereby achieving the purpose of welding. Compared with traditional welding, handheld laser welding has the advantages of l...

The protective lens of the laser welding machine is consumable, so it needs to be replaced regularly. However, due to the influence of the process/technique/setup, etc., it may cause damage by slag retrieval. In rare cases, abnormal laser light output and other factors may a...

1.The speed of the marking machine: This refers to the speed of the laser scanning galvanometer. This speed refers to the speed that can be adjusted in the parameters, rather than the overall speed of marking a product. Because the overall marking speed is not only adjusted by th...

During the operation, choosing different parameters and marking workpieces of different materials will affect the marking depth of the laser marking machine, sometimes resulting in the marking effect being too shallow or too deep. In fact, the marking depth of the laser marking m...

During long-term use of the Aurora cutting machine, some problems will always occur. So what are the frequently encountered machine problems and basic solutions?1. The laser cutting head does not emit lighta) Check whether the water circulates normally and allow the water to circ...